Ford Festiva (3)
Mazda RX-8 (1)
Purchase/ Finance (3)
About this site
Links to us
General :: Outside the Cube :: Auto :: Maintenance
Tips on maintenance of your vehicle.
This list is sorted by recent document popularity (not total page views).
New documents will first appear at the bottom.
Generated 12:01:12 on Oct 21, 2018
How to Change Radiator Fluid
The coolant in your car's cooling system needs to be changed every year in cold climates or every two years in temperate climates. If the coolant is changed regularly, there's no need to flush the cooling system.
Draining the Cooling System:
Then fill it with a 50:50 water/ antifreeze mix:
- Open the radiator cap with the engine cold.
- Crawl under the front of the car and look at the bottom of the radiator. Find the radiator "drain cock" (also called the radiator petcock). The drain cock is a small plug or T-shaped bolt located at the bottom of the radiator. Sometimes it's plastic.
- Place a large pan - 5 gallons or so - under the radiator. Open the drain cock with your hand or an appropriate-size wrench. Allow the radiator to drain into the pan.
- Close the drain cock.
- Refill the radiator with water until the water is at the top of the radiator or just visible.
- Replace the cap.
- Run the engine for 5 minutes to circulate the clean water.
- Stop the engine, allow to cool slightly and repeat steps 1 through 4.
- Add a mixture of 1/2 water and 1/2 antifreeze to the radiator. Fill it right up to the top.
- Fill the overflow/coolant reservoir with the same 50-50 mixture.
- Leave the radiator cap off, turn the engine on, and let it run until the radiator "burps." There may be pockets of air trapped in the system: You'll see the coolant level drop and may see a large air bubble come to the top as the system burps. Be sure to keep an eye on the temperature gauge throughout this process.
- Refill the radiator to the top and the coolant reservoir as needed.
- Put the radiator cap back on.
- Add more coolant if the engine runs hot after this procedure - there may have been another pocket of air that burped.
- Put the old coolant and water in plastic jugs using a funnel.
- Dispose of coolant properly - don't pour it down the drain or sewer. Many service stations, repair shops and parts stores will take it so it can be recycled, or you can take it to a recycling center.
|Most recent comments